TOOL 01AVAILABLE
Cabinet Hinge Finder
Match concealed hinges by cup diameter, arm geometry, overlay, mounting style and markings.
- 35 mm & 26 mm cup reference
- Direct / retrofit / no verified match
Replacement hardware reference
Identify it. Measure it. Replace it right.
A practical reference for old, discontinued and hard-to-match cabinet hardware. Start with the part in your hand.
35 mm cupoverlaymounting platestamped numberdirect replacementretrofit
TOOL 02RESEARCH MODE
Drawer Slide Finder
Record mounting, clearance, length, motion and clip details before choosing a replacement.
- Side-mount, undermount & roller
- Measurement checklist
Documented configurations
Verified Replacement References
These examples apply only when the complete installed configuration and measurements match the documented case. A family marking or matching dimension alone does not verify compatibility.
DIRECT REPLACEMENT
Blum COMPACT 33
Screw-on hinge 33.3600 with two-hole edge plate 130.1100.23, 12.7 mm overlay, 35 mm cup and 45 mm door screw spacing: 38N355B.08.
Existing cup screw holes and two frame-hole positions can be reused; new #8 × 3/4-inch truss-head frame screws are required. Check door clearance before ordering.
See Blum COMPACT 33 configurations and sourcesRETROFIT REPLACEMENT
Grass TEC 830
Face-frame hinge with plate 830-33, 31.75 mm overlay and 35 mm cup: TEC 864 04493-15.
The existing cup bore and frame plate holes can be reused for this documented case; new door-side screw holes are required.
See Grass 830 configurations and sources01Measure
Record visible geometry.
02Identify
Compare family evidence.
03Replace
See the installation impact.
Reference practice
Good replacement work starts with the mounting details.
Part numbers, cup holes, overlay and cabinet construction each matter. Use the Finder to collect what you know, then verify before ordering.